Hi ! My print of "INFINITE CUBE" by "DHOZER" Printer: "Ender-3 V3 SE" File "Cube.stl" Scale: 100% Sliced with: Creality Print v4.3.6 (material "CR-PLA", quality "Normal") Layer height: 0.2 mm Filament used: ArianePlast PLA+ Silk Blanc Printing time: ~ 1h43 To print this model without using supports, - you must orient it correctly (Rotate X=-45.00° Y=-35.53°), - move a small part of the model under the print bed, to obtain more surface in contact with the bed (Move Z=-3.60 mm), - you must also activate a brim as print bed adhesion type, - have a very clean bed (freshly clean with IPA 99.9%), - have a well-adjusted Z-Offset - and to activate a Z-Hop (of for example 0.2 mm). (I had 2 printing failures because I had not activated the Z-Hop) Under Creality Print, ignore the message which tells us that we are printing an object outside the limits of the printing volume (this is normal, as there is a part of the object under the plate, part which will therefore not be printed, but otherwise there isn't enough surface area in contact with the print bed, and otherwise it would be necessary to add printing support.) After removing the brim, passing a quick flame with a lighter to make the few angel hairs disappear and quickly scraping off small defects. Posted as an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c "November 3D Printing Event" https://www.crealitycloud.com/contest/november-3d-printing-event Good continuation to all !