This is my print of "One layer test print" I had a few issues with adhesion, it stuck a little too well to my bed, if my bed was a glass bed i would have had even more problems getting it off, bc of the print i will readjust my bed, so its perfect. Printer: "Ender-5 pro" Supports: No Scale: 100% Sliced with: "Ultimaker cura" Layer height: 0.2 mm Filament used: CR-PLA White Printing time: ~ 0h 5m Print speed 80mm/s This is an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c "November 3D Printing Event" https://www.crealitycloud.com/contest/november-3d-printing-event