Exactly what Vase Mode was designed for - Vase by [%8146959897] Another make as part of the November printing event https://www.crealitycloud.com/contest/november-3d-printing-event and taken from the current leaderboard. If you are new to 3DP you may hear the term vase mode but not know what it means. Vase mode is where you set your slicer to use zero infill and no top layers. The model is then printed with a single wall and tends to make for much faster prints. This model is designed for exactly that. Really nice clean design that prints really well with the Z seam really well hidden too. I have rotated the images so you can see how well the seam is hidden. Great design. Printed on my K1 Max, sliced via creality print and printed in Creality Hyper Series PLA in white. I'm growing to love this filament as I was able to print this model at 190 mm/s with 20% infill and massively reduced the print time over some of my older printers using conventional filament. This PLA is strong too and is great for vase mode models. [%9196945991][%9631304319][%9437581472][%2443000667][%6356661089][%4952650410][%5271107097]