I have a particular problem with my K1 Max. The issue I am having is that between prints, or a period of not printing, the filament would snapp between the filament runout sensor and the extruder. The printer would print the first layer and then pauses. I would need to remove the filament between the extruder and the run out sensor and reinsert the filamement as if its a filament change. I don't recall this happening with the Hyper PLA, but it has happened with multiple new spools across several venders. I have checked and the spool freely spins and the filament is not getting tangled. The filament is not brittle and I am not sure what is causing this to happen. I think i may replace the bowden tube to see if that is the cause. Anyone else have this issue?