Attention:
accompany the wing and ball during the first joint.
The brim is mandatory. I repeat: mandatory, as is the zhop. I remind you to watch the tutorial if necessary.
https://www.patreon.com/posts/z-hop-91398118

NOZZLE: 0,4 mm.

LAYER: 0.16 or less
OUTER WALLS: 3
INFILL: 10%
SUPPORTS: NO
Z-HOP: 0,8
BRIM: absolutely yes

Printed at 100% and 90%. I do not recommend printing them smaller than 80%. Be patient.
I hope you can have fun and enjoy this lovely dragon.
Careful not to break the wings and get hurt, some filaments create more thickness!

AMS/MMU READY: you can use “SMART FILL ANGLE”, easy!

For personal use only

All my files are protected by Copyright, should NEVER be shared or resold. To legally sell physical print of my design and if you want to get

the latest Models and exclusive designs for your support visit:
www.patreon.com/Bottega3D