K1 Max - Help with Orca Slicer Settings for ASA Hi there, I've just purchased a K1 Max so I can print ASA. The printer has recommended settings on the label at the bottom of the enclosure. I just wanted to get some advice around the filament and cooling settings to see if I have them correct? A little unsure if I should still keep the part/model fan speed at 80% for overhangs and short layer times? I have turned the exhaust fan off completely during printing - assume this is the side fan? If using the textured build plate, Orcaslicer has a default temp of 60c? Everything I've read recommends around 100c. I tried printing a temp tower a few times but came unstuck. Adjusting Z offset didn't really help either. I have got some spray glue to try now as well to try. (Using a 0.6mm nozzle with 0.3mm layer height) Any other advice / help with the settings would be greatly appreciated! Have added a pic of the first layer going down using the new spray adhesive.