Hey! Since the relief fidget toy design competition is going on, lets bring back the ultimate stress relief toy from the good old days. I present you falconsson Antistress Coil. PRINT SETTINGS (IMPORTANT) 1-The trick to print this design is to print it slow and with a cold nozzle temperature (go with the minimum suggested temperature for the filament of your choice). if you are using an enclosed printer, leave the front or top open. 2- new printers such as k1, k1max, k2plus, bambulab printers etc.. are too fast, slow down print speed by 50%. My print time was around 2 hours 41 minutes. 3- Supports: "DO NOT USE" or you will not be able to seperate the layers of the spring. so do not use supports. 4- Bed adhesion: if you have bed adhesion problems you can print this model with 3-5mm edge, i did not need it. 5-Suggested filament: i used "ESUN SILK PLA" for the test print shown in visuals, its recommended to use similar to have funky colors and easy printing experience.Wish me luck in the competition, May the perfect first layer be with you, See you on the next design![%1786422819]