BUMPER AIR HOCKEY

There are a number of Air hockey games out there. I wanted to do something different with this one to increase the fun and challenge level so I added tunnels and pylons.

Contrary to the more traditional air hockey game this one is designed to make it direct net shots impossible on account of the pylons. Shots need to be calculated using curves and angles.

To add to the fun, I added side tunnels. They have a narrow entry but if the shot is set up correctly then the exit should make for the net. Beware the tunnel side corners as they are angled to cause a rebound in your own net.

FEATURES

Bumper Air hockey features:

* A large game area (55 x 23 cm);

* Fast paced action - you will need to master angle and curve shots;

* Interchangeable pylons - two sets of pylons are provided and you get to set the difficulty level;

* Two sides tunnels for added fun;

* More fun and challenge;

* Easy to assemble - a pdf instruction guide is provided (you need to download it separately - it is the last file under the file tab);

* Easy to print - little to no support is needed;

3D PRINTING

PRINT SETTINGS

IMPORTANT: After verification with Creality it appears that there are some issues that need to be resolved with the mobile printing app. At present it seems these may affect slicing and printing of the model. After verification, it was suggested by the Creality Cloud team to use the desktop slicing and printing software. Thank you for your understanding.

IMPORTANT I upload a print setting files for all my models. The print settings has the parts positioned for correct printing.

EACH BUILD PLATE HAS THE TYPE OF SUPPORT REQUIRED INDICATED ON THE BUILD PLATE DESCRIPTION (TREE AUTO, TREE MANUAL OR NO SUPPORT).

I strongly recommended you use my print setting file. If not, I will not be able to assist you if there is an issue when printing. From experience, many of the issues with printing my models are on account of users not using my print settings.

ASSEMBLY AND INSTRUCTIONS

A pdf instruction guide is provided (you need to download it separately - it is the last file under the file tab);

3D PRINT SETTINGS

I use the following settings and materials to print this model:

Infill % : 15% (no need for more)

Nozzle diameter: 0.4 mm

Layer height: 0.2 mm standard

Material: PLA or PETG