Sky Stream Wall Mount – Compact Cable Management Box

A compact wall-mounted enclosure designed specifically for the Sky Stream box.

The Sky Stream box slides into the holder while the cables remain accessible from the top. It helps free up space near the TV, keeps the setup tidy and reduces visible cable clutter.

Features
- Designed specifically for Sky Stream
- Compact wall-mounted enclosure
- Keeps the Sky Stream box raised and organized
- Top openings for power, HDMI and other connected cables
- Four mounting points for stable installation
- Minimal and clean design
- No supports required

Compatibility
This model was designed and tested with a Sky Stream box.

Before printing, please check that your device matches the dimensions and connector layout shown in the photos. This model may not fit Sky Q, Sky Glass, Sky Plus, or other Sky devices.

Printing settings
- Tested material: PLA
- Layer height: 0.20 mm
- Infill: 20–30%
- Walls/perimeters: at least 3
- Supports: not required
- Orientation: print the rear plate flat on the build plate, as shown in the technical image

PETG can also be used if you prefer greater heat resistance.

Wall mounting
The holder features 4 × Ø4 mm mounting holes.

Use screws and wall plugs suitable for your wall type and the expected load. The holder was tested using all four mounting points.

Always check that the installation is stable before placing the Sky Stream box in the holder.

Important safety note
This holder was printed and tested in PLA.

Make sure that the ventilation openings of the Sky Stream box are not blocked. Do not install the holder close to heat sources or in direct sunlight.

Check the temperature of the device and holder during the first uses. If the Sky Stream box or the installation area becomes unusually warm, consider printing the holder in PETG.

Share your make
If you print it, please upload a photo of your installation.

Likes, downloads and feedback are greatly appreciated!

Modelli di stampa 3D Sky stream e file STL gratuiti