Hi ! My print of "pikachu funko pop" by "PressPrint" Printer: "Ender-3 V3 SE" For all files Scale: 100% Sliced with: Creality Print v4.3.7 (material "CR-PLA", quality "Normal") (Quality ->) Layer height: 0.1 mm, Initial Layer Height: 0.2 mm. (Shell ->) Z Seam Alignment: User Specified, Z Seam Position: Back Left, Z Seam X: 0.00 mm, Z Seam Y: 110.00 mm. (Infill ->) Infill Density: 10 % File "Body.stl" Z move of -0.8 mm, to have more surface in contact with the plate. Be careful, this file seems to have geometric errors. And the slicing result may not be as expected. (With Creality Print v4.3.7.6619-win64, profil quality "High Quality", I obtained slicing results where some socket gaps were partially filled, I had to use the "Normal" quality profile with modifed layer height 0.1 mm (but not the initial layer height) to obtain consistent slicing during preview.) (Build Plate Adhesion ->) Build Plate Adhesion Type: brim. Support > Generate Support: Yes, Support Structure: Normal, Support Placement: Touching Build Plate, Support Overhang Angle: 85.00°. Filament used: Velleman PLA Yellow. Printing time: ~ 2h31 For the other files (Build Plate Adhesion ->) Build Plate Adhesion Type: skirt File "eyes black.stl" During printing I reduced the feedrate to 50%. To be sure to allow time for the already printed part to cool sufficiently. Filament used: Velleman PLA Black. Printing time: ~ 0h15 File "cheecks red.stl" Filament used: Velleman PLA Red. Printing time: ~ 0h09 After removing the printing supports, sanding/scraping the printing defects, and assembly. Posted as an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c "November 3D Printing Event" https://www.crealitycloud.com/contest/november-3d-printing-event Good continuation to all !