Strike a Light - Candle Flame by [%5027181331] Yay, I think I got the first make as part of the November Print Event https://www.crealitycloud.com/contest/november-3d-printing-event. This lovely little model is a cover for battery operated tea lights or similar. It has very thin walls to show the light better and the bonus is that it also makes for a very quick print. The downside is that you will need to use a brim for added bed adhesion. Great little model that is also a good speed test for the K1. I printed this one at 200mm/s and I think I could have gone quicker too. Good job. I have not cleaned the model after printing to show exactly what you will get if your settings are nearly bang on the money. Printed on a K1 Max, using Creality Hyper White PLA Filament, sliced on Creality Print with 0% infill, 200mm/s and no supports but you will need a brim or you end up going all Italian with spaghetti. [%9196945991][%9437581472][%6839402488][%2443000667][%9631304319][%4360916776][%4952650410][%1320011900][%6356661089][%7554303452]