This is V2 of the Door Hook for Hangers model I tried recently. (35mm model) The hanger hook slot height is perfect and I don't have to rotate the hanger at all to get it in now! I didn't realize how much of an improvement that suggestion would be! This is much much easier to use now, thank you so much! I have a couple more ideas if you decide to do another version - 1. The width of this model (at 25mm) is far too large for this particular hook. When printed on its side, this model is extremely strong, especially with petg. I lowered mine to 15mm and i could probably have gone to 10mm without any loss in function. The model's 25mm is overkill for hanging clothes, unless your clothes are a suit of armor. 2. A nice QoL improvement would be to add a fillet to the outer edges of the entire model. Not only is the 90 degree angle sharp, but the hanger hook only rests on the two pointy tips of the perimeter of the hook slot. That fillet would help the hanger rest more 'comfortably' since it's curved, and I think it would also give the entire model a little better aesthetic. Those two things are minor though. This V2 is a wonderful functionality improvement over V1, thanks for taking the time to make the changes.