Hi ! My print of "Ice Wolf - Monstrous Creature - PRESUPPORTED - 32mm Scale" by "Printed Obsession" Printer: "Halot-Mage Pro" File "STL_Ice Wolf_Supported.stl" Scale: 100% Sliced with: Halot Box (v4.4.0.3575 win64) Layer height: 0.05 mm Resin used: Creality Water Washable Resin Plus White Exposure time of normal layers: 2.2s ( printing environment temperature: ~13°C ) After a quick soak in a "dirty" 99.9% isopropyl alcohol tank, removal of most of the printing supports, cleaning again but this time in a "clean" 99.9% isopropyl alcohol tank, a drying time, a UV treatment (~2 minutes) and removal of last pieces of printing supports. This print is not a complete success (but not a complete failure either), as certain printing supports for the tail did not play their role (I must probably be a bit underexposed or I need to reinforce/add printing supports on this area. Moreover the temperature of my printing environment outside the recommendations for this resin should not help.) Posted as an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c "November 3D Printing Event" https://www.crealitycloud.com/contest/november-3d-printing-event Good continuation to all !