Hi all I bought an new camera as you can see in my post before. I went searching for an answer how to connect the new camera nebula from creality. The only two options were sending back ( what I still need to do because the camera is sort off broken) and buying the Sonic pad, the last option I did. After long trying it finally worked, but also with the sonic pad I’m having trouble, but after the support from creality I came to this moment where I’m printing an support for the Sonic pad connecting to my printer on the side. But I’m a little bit nervous for an shutdown and reboot tomorrow after the print. I had some errors with connecting the Sonic pad as told before, I rebooted after the support from creality and it crashend again. I completelyreinsed everything the normal software back on the printer and factory reset on my Sonic pad, I didn’t rebooted after that and started printing the support for my Sonic pad. So I hope there are no troubles tomorrow, but if that would be the case I will contact the Creality support and work with them to an solution. Now a little bit about my first printing contact with Sonic pad, this is in a few words the best solution for printing ever. It’s much faster I even slowed it down, also the print is ten times better than before. So if your considering an Sonic pad get one now😎 As you can see in the picture the printing time on the Sonic pad is 15 hours and the same print with old settings from my cr-m4 printer is more than 18 hours. I’m really happy with the help I’m getting and ofcourse with my printer and Sonic pad together.