I just got this new PLA filament from "Azurefilm". I printed a few models, but all of them went horrible, with stringing poor adhesion and bad quality. The filament i used before which was a filament from creality worked perfectly. This new filament feels rougher that creality's CR-PLA. Is it just me having problems with this filament or others too, if anyone has an idea on how to fix this, then please comment, i would really like this filament not going to waste. This is the link to the filament: https://azurefilm.com/product/pla-original-filament-white/ I printed at 80mm/s, 60 degrees bed temp and 200 degrees extruder temp.