A star of a Christmas Tree - Articulated Christmas Tree by [%9162649526] Yay, I think I got the first make as part of the November Print Event https://www.crealitycloud.com/contest/november-3d-printing-event was the perfect opportunity. This fantastic little model is dead easy to print and I managed to get decent bed adhesion with the Hyper Series PLA filament so dint need any brims. You might want to do a test before doing a full print to make sure you dont need a brim with the filament you are using. Printed on a K1 Max, using Creality Hyper White PLA Filament, sliced on Creality Print with 15% infill, 170mm/s and no supports or brims needed. I think I could have gone quicker. I thinks is more of a pop up tree as opposed to an articulated tree but it prints really well and the action works well too. Enjoyable print to make. Well done [%9162649526] The model has not been cleaned up after printing so you can see the actual results. [%9631304319][%9196945991][%9437581472][%6839402488][%2443000667][%4360916776][%1320011900][%4952650410][%5271107097][%6356661089][%7554303452]