👩🏻‍🍳 Dishwasher sliding sign

Description

Source link : https://www.thingiverse.com/thing:2867275 - Change From Green to Red at or between 2.6mm to 2.8mm When the red word Dirty is complete, you will see the sidewall edges form around the word "Dirty", and that tells you it is time to change to Silver to complete the print. - Change from Red to Silver at or between 3.3mm to 3.5mm In the slicer orient "Clean_Dirty_Sign_Partb01.STL" with the word "Dishes" at the bottom by rotating on the X axis 180 degrees. *Optionally, (advanced) print with Dishes facing upwards with support material as originally oriented - adjust color change as needed. Start printing the "Clean_Dirty_Sign_Partb01.STL" with the color Silver and change to Black after about 3 to 4 layers at 0.2 layer resolution or 5-6 layers at 0.15 resolution so that the word "Dishes" is Black and finish the part in Black. - Change from Silver to Black at or between 1.4mm and 1.6mm Post Printing: Glue three 10mmx1.5mm magnets in the three recessed holes on the back. Cover with masking tape and trim so you don't scratch your dishwasher with the magnets. 10mm with 1mm thickness would be fine also - like these: https://www.amazon.com/MosShop-Refrigerator-Magnets-50pcs-10mmX1mm/dp/B07176K33G/ref=sr_1_9?ie=UTF8&qid=1524023465&sr=8-9&keywords=10mm+magnets Break a magnet in half (or optionally use whole magnet) and paste the parts on the inside of part B (the "Dishes" part) next to each side wall as depicted in the picture of the Black part. Before you glue, check your polarity with the main part for magnetic attraction to the "Clean" and "Dirty" sides of the part A. You can snap the two parts together to check this. Snap Part A to Part B and place it on your dishwasher. If the magnets are causing repulsion such that the slide does not snap to clean and dirty then reorient the magnets on Part B.