🪴Succulent dome

Description

Source link : https://www.thingiverse.com/thing:2485899 Summary Something to decorate your desk :) Dome: PolySmooth™ Transparent Printer: Mass Portal Pharaoh ED15 (0.6 nozzle) 0.2 layer height 0.75 extrusion width 210˚C / 60˚C Vase mode 40mm/s printing speed (with cooling overwriting) (Lower the jerk and acceleration of your printer if its a commun cartesian printer :) ) I poor alcohol inside to the top (like a cup) for 3-5min, I then polished the outside faces with the Polysher for 3*10min (5min drying with a fan). Base: PolyWood™ As for the base I used the same printer, PolyWood™ profile with over extrusion, sand it down slightly with a file then use a lighter to even out everything. The succulent is not from me but I dont find the link anymore so I post the stl i downloaded :( It was smth like this : https://www.thingiverse.com/thing:2314536 Hope that help :) Print Settings Printer: Mass Portal Rafts: No Supports: No Resolution: 0.2 Infill: 15% Notes: I used the Polysher to polish the transparent cover and the succulent.