Fight club soap mold

Description

Not Mine Found: https://www.thingiverse.com/thing:2686242 This is a 3D printed mold to make the fight club soap Print Settings Rafts: Doesn't Matter Supports: No Resolution: 0,15 Infill: 30-40% Notes: be sure to have at least 2 top layers parameter before printing Post-Printing To make the soap: For mine I used candle wax, but I'm pretty sure soap could work as well. First you need to clean your print and check for any holes in the mold. If there some , fill them up (varnish works well). Then put a fine layer of lacquer. In order to help the released, put some dish soap on the mold. After that you can start pouring the wax or the soap(don't put to much). Wait until it's solid and put it in the freezer, and after that you can release your soap