Printer Setting Instructions

 Set Up the Slicer

Slicing Software: Use software like Cura, PrusaSlicer, or Simplify3D.

Layer Height: Lower values (e.g., 0.1 mm) for fine details; higher values (e.g., 0.3 mm) for faster prints.

Infill Density: Adjust based on strength requirements (10-20% for most projects, higher for strength).

 Prepare the Printer

Level the Bed: Ensure the print bed is level for proper adhesion.

Clean the Bed: Use isopropyl alcohol to remove dust or grease.

Check Filament: Ensure the filament is properly loaded and free from tangles.

 Monitor the Print

First Layer: Watch the first layer to ensure proper adhesion and no warping.

Temperature: Maintain the correct nozzle and bed temperature for the material.

Watch for Issues: Pause if you notice under-extrusion, stringing, or layer shifting.

 Post-Processing

Sanding: Sand the print for a smoother finish.

Painting: Apply primer before painting for better adhesion.

Resin Prints: Wash with isopropyl alcohol and cure under UV light.

K1 Printer, approx. 25 min print time FOR BOTH PRINT , 0.2mm layer height, 10% infill, PLA material.

, print in place.

Happy Easter Decor

Lets Print 3D