This is a remixed version of the impressive vented LED riser created by JesusFreak on Prinables for the ****** Centauri Carbon. I am particularly fond of the model on my CC, so I had to scale and modify it for my K2 Plus. I incorporated the K2 Plus logo in the center under the slider tab for vent opening and closing, as well as the Creality logo on the front corners.

I experimented with various logo options: inset, raised, or none at all so you have options.

You will require two of the shorter length vents one for the front and one rear, and two longer ones for the sides. Additionally, you will need the four corners marked as indicated. There are separate plates for each along ones for all vents and the corners ready for printing.

The total printing time is approximately 15 hours, and the filament usage is around 520g.

I printed the riser using PETG, with three walls and a 15% Gyroid infill. I used a brim just to help ensure good bed adhesion and there is also supports on the rear corners where the cutouts are for LED wires if added. It has held up exceptionally well. I initially placed my CFS on top without any issues, but recently added a second one and relocated them both to the side of the printer. Feel free to adjust walls, infill etc. as you'd like.

After printing, you will need to release the sliders by pressing on the bottom and top of each vent hole. Additionally, you may need to press the tab that opens and closes the vents to release them, a gentle tap in one direction can help free them.

I hope you enjoy this print and please give JesusFreak on Printables many Kudos for this design.

K2 Plus Riser

PrintDaddy2024

Tetapan Cetak(1)

0.2mm layer, 3 walls, 15% infill

Penerangan

Lesen

Tag

Model Berkaitan