One wall. One system. Built your way. The RJC Wall Organizing System is a modular grid you print and assemble yourself — bands join in both directions, accessories click in and out in seconds, and the whole frame finishes like a picture frame. Designed by my AI, printed while I slept. Printed, fitted, and tortured until every click felt right — so you don't have to.
This is the complete frame system — the exact setup running on my own shop wall right now. My build is a full 3×3 grid: nine bands, 720×360mm of organized wall, assembled, mounted, and loaded with tools and accessories.
How it works:
- Bands (240×120×10mm) stack vertically and side-by-side
- Splines slide into the band grooves and join them with a friction fit — snug in the hand, separable when you want to rearrange
- End caps close the exposed grooves and finish the frame — the corner pieces wrap the corners so the whole grid reads as one framed panel
- Accessories mount with the click-fit drop-in system: v4.3 posts (5.6mm stem, Ø12.5mm tapered head) drop through the Ø14mm entry holes, slide down 40mm, and seat with a solid friction click. Lift to remove. Rearrange your wall in minutes, no screwdriver.
What's in this listing:
- Top Band v3, Middle Band v3, Bottom Band v3 (240×120×10mm each, 4 mount slots per band)
- Splines v2 — Vertical 232 and Horizontal 96, friction fit, ends flush with the band faces
- End Caps v4 — 240 (top/bottom edges), 120 Side (plain sides), 125 Side Extended (corner pieces — install LAST, flip end-for-end for bottom corners), 130 Side Extended Both (single-row builds)
Build it your way: a single column, a wide row, or a full grid. For a 3×3 like mine you need: 9 bands, 6× 240 end caps, 2× 120 side caps, 4× 125 extended corner caps, and splines for every joint.
The accessories (separate listings, all fit these bands): Mail Holder, Key Hooks (narrow + wide), Pen Holders (left + right), and the Shelf — with more in the pipeline. Print the frame now and every future accessory has a home waiting.
Specs:
- Band: 240×120×10mm; full 3×3 grid: 720×360mm
- Slot grid: 48mm spacing, 4 slots per band
- Post interface: v4.3 (5.6mm stem, Ø12.5mm tapered head, 7.10mm total protrusion)
- Joinery: spline friction fit, hand-separable
Printing suggestions:
- Orientation: pre-oriented, print as-is
- Supports: none needed
- Brim: recommended on the bands — large flat parts, bed adhesion matters
- Layer height: 0.2mm standard; 0.28mm for faster functional prints
- Walls/infill: 3 walls, 15–20% infill
Material: PETG recommended — wall-mounted parts take daily handling; PETG holds up. PLA prints fine too.

RJC Wall Organizing System - Modular

RJCustomCreations

Ustawienia druku(0)

Opis

Licencja

Tagi

Powiązane modele