This is the first time printing on glass and it’s taking really well to everyone who has just started out I know is exciting to print your first print and it looks rubbish we’ll look at lot’ of videos about cleaning and slicing and bed adhesion it’s so important to keep your machine clean and keeping the room temperature as Evan as possible it only take a little bit of filament in one of the belts that will shift your print and dirty wheels clean them keep all wheels on the rails just the rite pressure not to tight and not to lose glue stick and white spirit brilliant for cleaning clean withe white spirit make sure your bed is clean even wash it with some and warmer get it clean and dry two ore three strikes of glue stick very light then rub in to your bed evenly all over let dry and away you go get printing you get 6ore7 prints out of that they sick real ell and let your print cooldown till cold then it will just lift off no digging in to the bed with your scrapers I hop this helps as it’s helped me and thank you for everyone’s who put them videos out there perfect prints every time