Hello digital world. I bring a question to you. I'm new to 3d printing, I have had a few successful small prints. But I decided to give a large print a try. I bought this printer for Halloween building costumes, and once I get about halfway through it goes starts printing off and breaking layers and the print fails. Bed temp is 60, speed if 100, infill is zig zag, pla temp is 200, using tree touching base for support. What setting works best? And I'm using pla from an xyz printer company from an old printer someone gave me. Why is it large builds fail halfway? Could it be that the pla from xyz printing is not good for the printer? Any help would greatly appreciate. Thank you. I'm running an out of the box stock ender 3 v2.