It seems like the K1 Max XY homing was not set up properly before delivery. There might be other issues as well. When I began the self-check, the head immediately moved to the rear right of the machine and continuously pushed against the ends of both axes. During the auto-leveling process, it barely moved a few millimeters away from that position and kept pushing against the corner ends. After dealing with the loud noises, I let it update the firmware, attempted to initiate a print, but it still remained stuck in that corner. I've tried rebooting, performing a factory reset, inspecting the wires on the two motors, and even examining all the tensioners, yet I'm unable to identify the source of the problem.