Why did this phone stand end up a mess ? I was printing a small catapult and a phone stand at same time. It all looked fine then when I checked in it around 60% completion there was just lots of loose spaghetti everywhere and a half finished phone stand. The printer seemed to be trying to drop PLA in thin air. Any suggestions pls? | Creality Cloud

 Designers 

 Workbench

 Messages

 English 

 Creality Cloud App

Models  Collections  Contests Leaderboard Community Products  Downloads  Blogs



Premium

 Upload



09:18 03-01

Follow

 Report

1

 4

Comment



Picture

All-in-One 3D Printing Platform

Creality Amazon Storefront Creality Wiki













Copyright © 2024 CREALITY 3D (HK) TECHNOLOGY LIMITED All Rights Reserved.