About the Set

Here’s one school supply you’ll never have to buy again. Kids will love having all their measurement tools printed in their favorite color!

This set was inspired by my son who, at the time of making this, is just learning to use these tools for higher math.

The compass snaps together so that it rotates freely enough but also does not come apart.

Recommended Settings

It sounds obvious, but don’t forget that rescaling your objects will throw off the measurements!

Assembly

Compass Assembly:

- Snap the pivot piece through the holes as shown below:

- Use a standard No-2 Pencil cut in half.

- The fit will be TIGHT but that is by design. You don’t want your pencil sliding around as you’re trying to draw circles.

Ruler Assembly:

- Ruler can be printed whole in build volumes greater than 12 inches.

- For best results, sand the edge of part 1 and part 2 of ruler that will be glued.

- Apply super glue between two pieces, align carefully, and hold until firm.

Happy Printing!

Commercial Use:

This model is for PERSONAL USE ONLY.

💲💲💲

If you would like permission to SELL THIS MODEL please subscribe to my Patreon here: https://patreon.com/davidsitgarage?utm_medium=unknown&utm_source=join_link&utm_campaign=creatorshare_creator&utm_content=copyLink

ruler

LegoRuler_v2