The initial layer has a major job to do as the foundation for the entire 3D t. The part not sticking to the print bed is one of the most prevalent es of a defective first layer. Improving surface adherence can mean the erence between a sloppy mess and a fantastic print. We'll show you four le ways to make sure a print stays on the bed for a beautiful initial layer y time in this article.

1. Make sure the bed is level.

Bed leveling is accomplished in a unique way by each printer. Some facturers use springs and screws, while others use bed-leveling sensors to letely automate the procedure. This is a crucial step to your first layer's ess.

2. Reduce the speed of the first layer

When the toolhead moves too quickly, it's difficult to get a print to stick he bed. The extruded plastic will bind better to the print bed if the print d is reduced.

3. Take a temperature reading

Temperature settings are most likely to blame if the first layer sticks but r splits from the print bed. The toolhead extrudes filament at the correct erature in many circumstances, however the platform is not warm enough.

Increase the bed temperature if your printer has a heated build platform to ove adherence. We propose increasing the bed temperature by 5 degrees at a until you can print a flawless initial layer.

If the first layer is still not sticking after increasing the temperature by than 10 degrees, check the other steps in first. It's unlikely that the erature of the bed causes the problem.

Check the filament you're using as well. The maker of the filament will lly propose an extruder and a temperature range for the bed.

4. Prepare the Work Surface

Cleaning the build surface might help if the prior methods don't solve your t layer issues. Wipe down the build surface with isopropyl alcohol (IPA) on gular basis to eliminate any impurities.

4 Easy Steps to Creating a Perfect First Layer