I printed this destroyer about two years ago it took me about two weeks to complete and two months to design every little part was scanned bib by bit so you can imagine how long it took but turned out amazing every part fitted smack on I’ve never put it in water it probably sink as it’s glued together but each compartment in the hull is water tight apart from the propeller hole . I printed in pla green + starting from the hull up turned out great spray paint was just grey primer well I hope you like my model and attempt to print it good luck [%6800227724][%4360916776][%1709415948][%6356661089]

 Designers 

 Bancada

 Mensagens

 Português 













21:24 11-04-2023

Seguir

Parâmetros de Impressão

Método de Impressão：FFF

Tipo de Dispositivo：CR-10 Smart

Material：Pla silk black and green

Altura da Camada：0.80mm

Velocidade de Impressão：60.0mm/s

Precisa de Suporte：Não

 Denunciar

 5

《Tonybell cow 》 Portfólios

Comentar



Foto