Hi ! My print, of "Silver Dragon Wyrmling" by "The Dragons Den". Slicer: Creality Print v4.3.8.6678 (Win). Printer profile "Ender-3 V3 KE_0.4 nozzel". Material profile "CR-PLA_1.75" modified (Temperature, Printing Temperature: 215.00 °C, Initial Printing Temperature: 215.00 °C, Final Printing Temperature: 215.00 °C, Auto Temperature: No.). Parameter config "Normal" (0.20mm). Scale: 100% File(s): silverdragonBaby7.stl Before slicing, lower the model by Z=-0.2 mm to have its bottom surface in good contact with the board (there seem to be some small points of relief on the bottom...) .gcode file: Z=-0.2 mm_silverdragonBaby7-Ender-3 V3 KE_0.4_CR-PLA 215_3h51m.gcode Filament: PLA Silk Rose ArianePlast (~ 23,741m) ~ 03 h 59 m 18 s During my first printing attempt I left the dragon as oriented (on the Y axis). But the end of my impression ended in failure because the head came off the plate (the horns were not printed correctly). So I redid a printing scene to only slice and print what was missing and I then glued them to the previously printed part. I therefore provide here a .gcode file which is not the same as the one I printed because this time I oriented the model in the X axis hoping that there will be less vibration of the plate at the end printing and that it will print correctly until the end without peeling the head of the platen. Posted as an entry to the "Christmas 3D Printing Event!" https://www.crealitycloud.com/post-detail/65839ead3e2577f851884efd https://www.crealitycloud.com/contest/christmas-3d-printing-event Print made as part of a test of the Creality "Ender-3 V3 KE" for https://www.lesimprimantes3d.fr/ https://www.lesimprimantes3d.fr/forum/topic/56116-creality-ender-3-v3-ke-la-d%C3%A9couverte-avant-le-test/ Good continuation to all.