The Story

We purchased curtain rods, but the store did not have proper mounting brackets in stock for these steel rods which are a bit heavier than the aluminium versions.

So, my Fusion360 and trusty K1C came to the rescue and after a few prototypes prints I finally have three sets printed, mounted and ready for the curtains.

I made these to fit 25mm and 19mm rods and the holes are for 5mm x 40mm nail anchors (which I had in my workshop).

I sized the opening in such a way that the rods will CLIP-in and should not move freely with the curtains.

Printing Tips

PETG or ABS Recommended for strength (my PLA prototype was also strong at 15%)

0.24mm Layer Height (or 0.20 if you prefer)

3 Walls

10-15% Rectilinear Infill (I did 10% and it is pretty strong!)

Tree Supports are recommended but I printed them without supports on my K1C and they look good.

Notes

You know how to mount them. - No tips here.

If you find these brackets useful in any way - please leave a LIKE

windows