G.I. Joe is the code name of a daring American special missions force whose purpose is to defend human freedom from Cobra, a ruthless terrorist organization determined to rule the world.

Their alternate names include the G.I. Joe Team, the Joe Team or, simply, the Joes.

1. Key Slicer Adjustments for Single-Piece Figure

Orienting the Model: Tilt the figure backward 10°–15° in your slicer. This places most support interface points on the back/underside of the model, leaving the front armor, chest details, and visor completely clean.
Support Type: Use Organic / Tree Supports set to "Everywhere". Tree supports reach around complex geometry with minimal contact area, making them far easier to clean off delicate areas like the arms, rifle, and swords.
Support Distance (Z-Distance): Set to 0.16 mm – 0.20 mm (equal to or slightly less than your layer height). This gives enough separation for supports to pop off cleanly without fusing to the hands or gun barrel.
Support Interface: Enable Top Support Interface (2–3 layers at 100% density). This creates a smooth ceiling for overhangs to sit on, reducing sagging under the rifle and sword crossguards.
2. Fine Detail & Print Stability Settings

Layer Height: 0.12 mm (or 0.10 mm if your printer is well-tuned).
Outer Wall Speed: 20–30 mm/s (Slow speed is crucial to prevent thin features like the gun barrel and sword tips from shaking during printing).
Wall Loops / Lines: 4 Walls (Adding extra walls makes thin extensions like the swords and rifle solid without relying on infill).
Z-Hop / Lift Z: 0.2 mm - 0.4 mm on layer change/retraction. This prevents the nozzle from knocking into delicate, free-standing support branches as it moves across the bed.
Minimum Layer Time: Set to 10–12 seconds. On the top of the helmet and sword tips, this forces the print head to slow down or pause, giving each layer of hot PLA time to cool and solidify before the next layer is deposited.
3. Post-Processing & Removal Workflow

Cooling Down: Allow the print bed to cool down completely to room temperature before touching the print. Attempting to pull or flex the build plate while hot can easily snap small parts like the ankles or gun stock.
Support Removal: Use flush cutters (nippers) to cut tree support trunks at their bases first, rather than pulling on them. Work from the outside inward, carefully snipping away connection points around the hands and weapon.
Cleaning Interface Marks: Use a sharp hobby knife or fine-grit sandpaper (400–600 grit) to smooth down any tiny support nibs left behind on the back/underside surfaces.

G.i. Joe

Vatraxi

Setări de imprimare(0)

Descriere

Licență

Etichete

Modele similare