Hi ! My print of "great ball container (0.2mm clearance)" by "PressPrint" Printer: "Ender-3 V3 SE" (nozzel diameter: 0.4 mm) For all files Scale: 100% Sliced with: Creality Print v4.3.7 (Material "CR-PLA" (Head 205°C, plate 60°C), Parameter config "Normal") (Quality ->) Layer height: 0.2 mm, Initial Layer Height: 0.2 mm. (Shell ->) Z Seam Alignment: User Specified, Z Seam Position: Back Left, Z Seam X: 0.00 mm, Z Seam Y: 110.00 mm. (Infill ->) Infill Density: 10 % (Build Plate Adhesion ->) Build Plate Adhesion Type: skirt or brim (Support ->) Generate Support: Yes, Support Structure: Normal, Support Placement: Touching Build Plate, Support Overhang Angle: 60.00°. File "outside top (blue).stl" Filament used: PLA Bleu Métallisé ArianePlast Printing time: ~ 3h04 File "outside bottom (white).stl" Filament used: PLA Eco Blanc ArianePlast Printing time: ~ 2h03 File "inside bottom (black).stl" Filament used: PLA Recyclé ArianePlast Printing time: ~ 3h04 File "inside top (black).stl" (Support ->) Minimum Support Area: 5 mm², Support Overhang Angle: 65°. Filament used: PLA Recyclé ArianePlast Printing time: ~ 3h06 File "boutton (white).stl" Filament used: PLA Eco Blanc ArianePlast Printing time: ~ 0h07 File "red .stl" Filament used: Velleman PLA Red Printing time: ~ 0h39 Post-print processing removing the printing supports, deburring, sanding/scraping the printing defects and gluing. I still have to do glue the two exterior parts (I didn't have enough glue left...), a quick blast with a heat gun to remove the last angel hairs, and posibly put a touch of lubricant on the tapping/thread, because it gets stuck a little to open if you screw, tighten too much. Posted as an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c "November 3D Printing Event" https://www.crealitycloud.com/contest/november-3d-printing-event Good continuation to all !

13:16 11-15-2023

Urmărește

Parametri de imprimare

Metoda de imprimare：FFF

Tip de dispozitiv：Ender-3 V3 SE 

Material：PLA (different colored filament)

Înălțimea stratului：0.20mm

Viteza de imprimare：180.0mm/s

Am nevoie de sprijin：Da

 Raport

 1

《My "November 3D Printing Event" entries 》 Portofolii

cometariu



Imagine