内容列表

Overview:
1. Retraction Distance
2. Retraction Speed
3. Adjusting Nozzle Temperature

Overview:

Stringing or dripping occurs when small strands of plastic filament are left behind on the printed object. Typically, this happens when the nozzle oozes material while moving to a new position. The most commonly used method to address stringing issues is called "retraction." When retraction is enabled, after completing the printing of one section of the model, the filament in the nozzle is pulled back, so that when printing resumes, the filament is pushed back into the nozzle and extruded from the top.

1. Retraction Distance

Solution: Adjusting Retraction Distance

Explanation: One of the most crucial settings for retraction is the retraction distance. This parameter determines how much filament is pulled back into the nozzle. Generally, the more filament that is retracted from the nozzle, the less likely it is to drip or string during nozzle movements.

For printers with a direct extruder setup, a retraction distance of 0.5-2.0mm is typically sufficient. However, for printers with a Bowden extruder or longer filament paths, a higher retraction distance of 4-10mm or more may be necessary, depending on the characteristics of the filament being used.

If you encounter stringing issues in your prints, try increasing the retraction distance by 1mm increments and observe the improvements in print quality.

	Adjusting Retraction Distance in Creality Cloud App Slicing Settings
	Adjusting Retraction Distance in Creality Cloud Web Slicing Settings

2. Retraction Speed

Solution: Adjusting Retraction Speed

Explanation: Another important setting related to retraction is the retraction speed. This parameter determines the rate at which the filament is pulled back from the nozzle. If the retraction speed is too slow, the filament may continue to ooze from the nozzle, resulting in leaks before reaching a new print position. On the other hand, if the retraction speed is too fast, it may cause the filament to disconnect from the nozzle, potentially leading to surface scraping or other issues.

For optimal results, the retraction speed typically falls within the range of 1200-6000mm/min (20-100mm/s). Creality Cloud app's slicing feature, along with other slicing software like Creality Print, provides some built-in default configurations to provide a good starting point for determining the ideal retraction speed. However, it's important to note that the best value may vary depending on the specific filament you are using.

To determine the most effective retraction speed, it is recommended to perform some validation tests by adjusting the speed within different ranges and observing the reduction in stringing.

	Adjusting Retraction Speed in Creality Cloud App Slicing Settings
	Adjusting Retraction Speed in Creality Cloud Web Slicing Settings

3. Adjusting Nozzle Temperature

Solution: Adjusting Nozzle Temperature

Explanation: If you have already checked the retraction settings, another common factor that can cause stringing issues is the nozzle temperature. If the temperature is too high, the plastic inside the nozzle becomes excessively viscous, making it easier for filament to ooze out. Conversely, if the temperature is too low, the filament remains in a harder state and becomes difficult to extrude from the nozzle.

If you have verified that your retraction settings are correct but still experience stringing issues, try reducing the nozzle temperature by around 5-10 ℃. This adjustment can have a significant impact on the final print quality.

For PLA filament, the normal printing temperature range is typically between 190-210 ℃. If the temperature is set too high, the filament may melt too thoroughly, resulting in insufficient retraction and increased stringing. Therefore, ensuring the appropriate nozzle temperature is directly related to the quality of your printed models.

	Adjusting Nozzle Temperature in Creality Cloud App Slicing Settings
	Adjusting Nozzle Temperature in Creality Cloud Web Slicing Settings

ศูนย์ช่วยเหลือ

Troubleshooting Stringing or Dripping in 3D Printed Models