Hello! I just got my Ender 3 V2. I assembled it successfully and leveled the bed and decide to do some bed leveling test prints. I placed a GCODE made for ender 3 v2 in the card and choosed the file. But nothing happened. It was on 0%. I waited a little bit and decided to click on the tune button and saw that the hotend temperature was under 200 degrees and I made it on 200 or a little bit above. I saw that the bed temperature was 55 (later on I saw that the bed is warm) and then the screen stuck. I turned it off and on and it is stuck on the Crality logo screen and nothing happen. I changed the firmware with some of Merlin and I receive an error: "Nozzle is too highterature", then changed it with another and just a black screen or again just the Creality logo screen stuck on. Then changed it with another FW and received error: "Printer Kill reason: Err: MAXTEMP Restart required" Basically I receive different errors or stuck screens with the different FWs. Does anybody knows why is that? Can anyone help me? Thank you in advance!