Are you tired of the poor camera quality of the Creality Hi? Wish you could see your prints with clear resolution and night vision?

I was frustrated with the camera quality of the stock camera in the Creality Hi, as are many others.

I have had wonderful experience in the past with Nebula Cameras and I discovered it works with the Hi without any modifications. The best part is you can find Nebula Cameras on eBay for ~$20 shipped!

Nebula Camera Mount Features:

- Tooless design: no tools or extra hardware required. Just snap onto your printer and go!

- No interference with blade cutter or functionality.

- Works with some other user cable chain designs (as shown).

- Cable guide: To keep the USB cable tidy and off to the side of the printer during operation.

- Camera Attachement: This is driven by a friction fit, no need for a thumb screw like most Nebula Camera Mounts.

- Raised modern Creality Logo on top surface for some bling!

Attachment:

This camera mount is designed to snap onto the printer.

1. Align the lip under the face of the camera lens. While doing this, also make sure the snap at the bottom rear of the mount is engaged.

2. Carefully flex the mount around the back such that the two vertical snaps are partially engaged.

3. Push the whole mount from the front horizontally towards the back of the printer to snap the two rear vertical snaps into place.

4. Finally engage the top left snap into the protruding block that activates the filament cutter when the print head slams into it.

Final comments: USERS! If you like this camera and mount, I PLEASE ASK YOU to contact Creality Support and express your frustration of them removing the AI detection features due to the poor quality of the inbuilt camera. With a Nebula Camera, quality is vastly improved over stock and AI detection should work without any issues. Lets get them to give us back this functionality!

I have the Nebula Camera on other printers and they are very good, and accurate with detections. There is no reason for them not be able to add this back onto the printer with a firmware update.

Let get this changed! It will be a community effort to get these features back.