Yes - this is my model. I’m putting it out there for everyone and anyone to remix, adapt, use, whatever. Have fun!

This basket is intended to clip around the purge switch mechanism, similar to the Bambu A1.

**Print Settings -

Layer height - .2mm

Walls - 2

Patterns - Monotonic/Concentric (faster)

Infil - 3%

Support - No

Skirt - No

Print Time - 2hrs 2min

Material used - 17.69m

Edit 1: added 5mm space for the clip, to make sure it fits properly.

Edit 2: Shaved 7mm off of left flange of clip, to fit between gantry and purge switch mechanism.

Edit 3: added a “chute” adjacent to the clip. Seems to work as intended.

Edit 4: Added a "Blank" version for customization, per feedback received.

Edit 5: Added a version with dovetails as to slide into one another, per feedback received. .1mm tolerances on the dovetail parts. Still prints in the same layout. (Basket - "SparkX" side down, Clip - Flat side down)