This model is a fully print‑in‑place tensegrity structure designed to work using only PLA, with no assembly, no flexures, and no post‑print activation. The geometry is tuned so that the tension members land at their final working length during the print itself, allowing the sculpture to stand in its tensegrity configuration the moment it comes off the bed.

The design uses a single central bridge as the tension element. This bridge prints cleanly in midair without supports, and its natural sag and cooling behavior create the exact pre‑tension needed for the structure to stabilize. When the final layers complete, the top platform is already held in equilibrium by the bridge.

The only supports required are for the inner anchor structures that the bridge connects to. These anchors cannot be grown entirely from below, so minimal supports are used during printing. Once removed, the model functions perfectly. The bridge itself requires no support, and the tensegrity effect is fully preserved.

The result is a self‑activating tensegrity sculpture:

Prints in one piece:

- Uses only PLA
- Requires no assembly
- Requires no activation step
- Stands in tensegrity immediately after support removal
- This makes it an elegant demonstration of pre‑stressed geometry, controlled bridging, and precision print‑in‑place design.

3D printing settings:

Resolution: 0.24
Line width: 0.45
Infill: 15% - Grid
Support: Yes, organic tree for inner supports only.

Note: Very carefully remove the tree support without breaking inner bridge.

Material:

PLA or PLA+

Tensegrity Mini Table

Eskimo Pie

Druckeinstellungen(0)

Beschreibung

Lizenz

Tags

Verwandte Modelle