Bed leveling an Ender 3 S1 Pro with a Sonic Pad I'm having trouble leveling my S1 Pro using a Sonic Pad. I do the Z compensation, manual level and then do the auto leveling, but it doesn't turn out well, even if I manually level again. Also, each time I use the auto level, the corrections keep getting larger. That can't be right. I use a 5 square leveling test and the middle square comes out okay, but the corner squares are blobby, regardless of the materials (PLA, T-glase, Tough PC) or the speed. See the picture. I'm using Cura 5.2.2. I was able to level quite well before I connected the Sonic Pad (although I had to manually level after an auto level). Anyone have any suggestions? Thanks.