Ender3 V3 SE with working Nebula Pad

Sensor-bracket model Dec 21, 2023

---https://cdn.shoplazza.com/1f3d64cd936758b2a21c3cae55dab663.zip---

(This is also from the same page.)

mount with the 2 hexscrews on the right side of the stock extruder;

make sure you print this with the 2 holes towards the bed els the screwholes wil not tighten.

Nebula Pad Firmware Dec 11, 2023

https://file2-cdn.creality.com/file/6f129aa0ef74b323e31177b122c04c74/NEBULA_ota_img_V1.1.0.23.img?spm=..page_11481319.download_support_2.1&spm_prev=..page_1934481.products_display_1.1

NEBULA_ota_img_V1.1.0.23.img on a usb stick just in case the Nebula pad has old img on it

(This is also from the same page.)

So now you have all from the same ufficiall site downloaded

1) -1. Ender3V3SE_firmware; Adaptive Ender-3 V3 SE

2) NEBULA_ota_img_V1.1.0.23.img

3) Sensor-bracket model Dec 21, 2023 ( stock SE)

Set youre Ender3 V3 SE back to factory original using the latest firmware that you can download from the creality site

https://www.crealitycloud.com/software-firmware/firmware/ender-series

Ender-3E-Marlin2.0.8.2-HW-V4.2.2-SW-V2.0.8.26-Raise-Z-20220318

Check if everything works ( i did auto leveling so i knew the printer is working)

Turn off the printer

insert the memorycard with the firmware an boot the machine

wait 5 minuts ( just to be sure :) )

turn of the printer leave the memorycard inside

unplug the screen

plug in the nebula pad

connect the camera and cable with sensor both into the nebula pad ( on the side 2x usb)

turn on the printer

do the setup until the screen download the img file into the printer there you wait 30 sec before going on

do the setup for the sensor and so one

if you have back the error

unplug live the nebulapad connection turn of the printer

reboot the printer without a screen wait minimal 5 minuts ( i wauted longer ) than i connected the original screen with the printer stil on and when you hear a loud beeb turn of the printer

plugin the Nebula pad again and boot youre printer

if everything gos as by me now you can do the self test.

as you have noticed you wil see youre Nebulapad in the software of crealitycloud/slicer were you can check if the temp go up.

the test takes some time 8/10 minuts so be patient

i hope this helps

It workt for me after 2 full days

Nebula Pad working