I love this Silver Dragon by The Dragons Den! I am used Eryone Silk Gold PLA filament, because who doesn’t love a gold dragon! I might actually try it in some Red Glitter PLA I have sitting on the shelf! I printed on a CR-10 Smart and it took just under 24 hours. I printed with a skirt and used blue painters tape to help with adhesion after having a few come off the bed on the wings. I did a bed level before and the gcode contains the command to use the mesh. For some reason it started a bit too close to the bed and pulled up some of the blue painters tape (you can see in the 3rd pic), but it only affected the skirt and so the print was able to continue!