Hey! I hope this pretty Kitsune will bring me luck! 🍀🦊 This pretty vixen was printed on a K1C with PLA Glow from Polymaker, 11h8 of printing for the 🦊 and 2h34 for the base, tree support, printing speed 220 mm/s, scale model at 150% 😌 As you can see in one of the photos there is a LOT of support, it took me about 40 minutes to remove everything, patience and concentration, there are a lot of fragile elements with the tails and 10% filling (triangle , better shear resistance, breakage is avoided by removing slightly stubborn supports) but I just find it beautiful 😅 It is therefore entirely possible to print it in filament (provide a filament that you are familiar with) Always a pleasure to bring to life the creation of [%2862586626] team 😌