Finally completed the K2 Pro Riser and Dual CFS Shelves. I used grey and black CR-ABS for the main structure and shelves. I also used Ender Fast PLA for the trim enhancements. The Ice Blue COB LED strip looks awesome with the blue trim enhancements. I made a rookie mistake, due to the lack of sleep, and downloaded the Riser Package for the K2 Plus. I stared blurry eyed at the monitor wondering why my settings were for the K2 Plus (knowing full well that I have the K2 Pro and the Ender 3 V3 printers…). After realizing my mistake I contributed more credits and downloaded the proper riser version for the K2 Pro. This is a top quality modular riser and very easy to print, although it does take a few days to print all of the components and add-ons. The project consumed approximately 1.5 rolls of grey CR-ABS and approximately 1/8th of a roll of the Black CR-ABS. The Ender blue PLA use was negligible by comparison. The design was very intuitive to put together once all the modules were printed. Although I didn’t think it was needed, I used small amounts of CA gel glue at some of the main structure’s critical joints as added strength. I also used some 1/4” wide 3M double-sides sticky foam tape as a means of removing any excess shifting of the riser when it was placed onto the K2 Pro. I cut small pieces and placed them at all four corners and at the four connecting joints on the front, back and sides of the riser. Again this was an awesome project for the K2 Pro and it was designed and created by [%5077138947]int int int .