I had this set for 0.6 nozzle, had poor results on other smaller models with consant failures. so changed back to 0.4 tip, but unawares left 0.6 setting on this model. took 25 hrs to print, i'll have about the same time next print cause it will be little bit smaller with 0.4 settings applied. chin,lower forearms and lower robe where it meets plinth need support on the next try. While the terraced asian fields is good for BUDDAS looks 0.4 settings printed with residual 0.6 tip & 0.4 layer, causing filiment slippage gaps and poor layer adheasion from forsing 0.6 volume through 0.4 tip. used marble and metalic gold on start of plinth, tip temp was 200, leaving pimples minimal blobs, lifted to 215 stoped zits and blobs 0.4 gap remained. next i will print same with correct? 0.4 tip settings 1 with supp 1 without. 215 tip 60 base.