Here is my print of "HummingBird" dragon by "The Dragons Den" [%7224035630]Scrolling through the many various dragons created in the "Den" This was my sons first choice. We typically are always printing together and i enjoy teaching him about 3D printing. We printed this on my Ender 3 V3 KE. I used a raft for the best adhesion and set an infill of 35%. I like to have a higher infill than recommended as this will be for my son and he can be rough on some prints. Shortly after print completion he did mange to find a weak point on the joint for the left wing and it broke. I glued it together for him, but if we print it again, we will make sure to increase infill. I used HP3DF PLA+ True Green for this print. This filament printed great with no issues at all. Overall, this is a great design and printed very nicely.Printer: Ender 3 V3 KESlicer: Creality Print V4.3.4.5553 (Win)Printer Profile: "Ender-3 V3 KE-0.4 nozzel"Scale: 100%Material Profile: "CR-PLA_1.75"