Hi guys, I seem to have a bed levelling issue with my K1 max. I’ve had it for 3 days and I decided to print a couple of squares to test the first layer as I’ve had a few issues towards the front of the bed with adhesion. It’s a the textured pei plate The top square was printed in the middle of the printer The bottom left was front left, bottom right was front right - as though you’re looking at the printer. To me the first layer squishing looks like it hasn’t done too well, especially towards the front right. Weirdly the squishing is a bit over the top towards the back of the printer, but only a tiny amount. To me this indicates the build plate isn’t flat. I’ve ran the self checks etc and it still hasn’t changed. I’ve had this printer for 3 days so I don’t really feel like pulling it apart, and I’ll contact support when they’re open tomorrow. It’s been like this since I’ve had it, I just thought it would iron itself out with a little use and self checks. Other than this it’s a great printer, it’s just that the first layer is so important. If anyone can suggest anything, or confirm what I plan to do, I’d be grateful. Cheers!