Hi ! My print of "pokeball container" by "PressPrint" Printer: "Ender-3 V3 SE" (nozzel diameter: 0.4 mm) For all files Scale: 100% Sliced with: Creality Print v4.3.7 (Material "CR-PLA" (Head 205°C, plate 60°C), Parameter config "Normal") (Quality ->) Layer height: 0.2 mm, Initial Layer Height: 0.2 mm. (Shell ->) Z Seam Alignment: User Specified, Z Seam Position: Back Left, Z Seam X: 0.00 mm, Z Seam Y: 110.00 mm. (Infill ->) Infill Density: 10 % (Build Plate Adhesion ->) Build Plate Adhesion Type: brim File "bottom.stl" Filament used: PLA Eco blanc ArianePlast Printing time: ~ 2h24 File "top.stl" (Support ->) Generate Support: Yes, Support Structure: Normal, Support Placement: Touching Build Plate Filament used: PLA Red Velleman Printing time: ~ 4h19 Post-print processing removing the printing supports, sanding/scraping the printing defects, (I needed to clean the supports and printing defects on the threading/tapping very well, and to file slightly to allow a closure where the two parts of the circle are well aligned.) I still have to do a quick blast with a heat gun to remove the last angel hairs, a few brush strokes of black and white acrylic paint for the normally black border and the normally white circle. Posted as an entry for "Introducing the Exciting November 3D Printing Event!" https://www.crealitycloud.com/post-detail/6540a6fc42c4bce0a33bd62c "November 3D Printing Event" https://www.crealitycloud.com/contest/november-3d-printing-event Good continuation to all !