Nooth Groosh ender 3 pro fan duct install. my machine: Ender3 pro, Microswiss Direct Drive, Microswiss hotend, creality pad, sunloo filament dryer, Creality bag, Cr-Touch I finished the install on the fanduct... still setting everything up. the top fan is not correct size i think because it fits poorly in the slot at the top. my nozzel needs a bit of cleaning but other than my poor cleaning habbits it was a nice install.I was using the Satsana fanduct but after installing Direct drive and a hotter hotend i needed to upgrade the fans. after searching for a bit i found this on Cults3d i believe or Thingiverse, it was a long night 🤣🤣 sooo what im getting at is what Fan Duct works best? The Satsana setups are a bit heavy Nooth Groosh setup is a tad bulky. and im not sure i like how big the air outlets are. I think air would be directed better with smaller outlet. what setups work... not just look good?