SOMETHING FOR THE PRINTER TRAY! Printed pefectly : PLA white. Decided to go with CURA ! ( didn't seem to have issues in refreshing the profiles??? had to uninstall it to refresh tampered with profile ? maybe I'm doing something wrong?) Creality slicer and Creality printer seemed to hold on to custom profile and not refresh???? Any Ideas on that.... And having a blast with the spiral mode ( vase mode?) The Heart Project! Most of this was to do with measurement ( units form maya to cura ) Got a bit carried away with all the different hearts , but wall thickness was a primary target as it cut down time and setting high tolerances for fitting lids. The spiral Curviture mode set at 0.6 wall thinkness ( default 0.4 on a 0.4 nozzle... looked it up cura stated the one could get 0.6 on a 0.4 nozzzle.... ) seemed to thicken the wall as there is only one in this mode. I increased the wall speed to 35% ( default 25%} I do this sort of stuff ( mainly because I know !! nobody is going to loose a limb by doing it ) Increase PLA to 220 Increased Hot Bed to 80... I what it nice and warm... All spiral mode turned out flawless... Also using Large High Flow Nozzles ( still 0.4 ) but a lot more brass.... cheers, Rich[%9794660155][%1959919003][%6800412449][%9923542197][%4360916776][%4558867644]