Halot one spill protection

263.33KBRelated 3D Model

Halot one has a bad design fault where the stepper motor is and where the wire goes through in to the bace

So I’ve designed a simple protective cover just to help stop resins getting down in to the stepper motor and down through where the wire comes up from the base all you have to do is print out and with a small bit of silicon ore 505 glue and stick it where the wire is that will give you 4mm off protection the stepper motor is a bit different just undo joint on the stepper motor and lift up with silicon ore 505 glue stick down in the hole it’s a nice fit the make sure there is a slight gap and tighten see photo that will give you 4mm protection it would be better printing in rubber but I used Petg filament this little fix will save you loads of money helping to stop resin entering the motor and electrics hopefully creality will use this small protective cover on future resin printers

@Mitch1967@CiCi@Creality After-sales@Creality